How to Take off Ring Doorbell Cover

Angel K. Vanleuven

There are a few reasons you might need to take off the doorbell cover on your Ring Doorbell. Maybe you’re trying to change the battery, or maybe there’s something wrong with the doorbell and you need to troubleshoot it. Whatever the reason, it’s not difficult to take off the cover.

  • Locate the small notch on the bottom edge of the doorbell cover
  • Insert a small flathead screwdriver or other tool into the notch and pry upward gently to release the bottom tab
  • Repeat this process on the top tab until both tabs are released and the doorbell cover pops off
How to Take off Ring Doorbell Cover


How Do I Get My Ring Doorbell Cover off Without Tools?

If you’re trying to remove your Ring Doorbell cover without any tools, there are a few things you can try. First, see if the cover is screwed on – if so, unscrew it with a Phillips head screwdriver. If the cover is glued on, try gently prying it off with a putty knife or flathead screwdriver.

If neither of these methods work, you may need to use a heat gun or hair dryer to loosen the adhesive holding the cover in place. Be careful not to damage the doorbell itself while doing this. Once the adhesive is loosened, the cover should come off easily.

Do I Take Plastic Cover off of Ring Doorbell?

Most people don’t realize that their doorbells probably have a plastic cover protecting the button. If your doorbell is looking a little dirty, it’s probably time to take the cover off and give it a good cleaning. Here’s how:

1. Start by taking off the battery cover. You’ll need a small Phillips head screwdriver for this. 2. Once the battery cover is off, remove the batteries and set them aside.

3. Locate the two screws holding the doorbell faceplate in place. Remove these screws with your screwdriver. 4. The faceplate will now come off, revealing the plastic cover over the button itself.

Gently pry this cover off with your fingers or a small flathead screwdriver. Be careful not to damage the button underneath! 5 .

You can now clean both the faceplate and button with a damp cloth (don’t use any harsh chemicals).

How Do You Take the Faceplate off of a Ring to Camera?

Assuming you’re referring to a security camera: Most security cameras have a removable faceplate that allows you to access the lens and sensor. To remove the faceplate, start by unscrewing any screws that are holding it in place.

Once the screws are removed, gently pull the faceplate off of the camera. If there are no screws, the faceplate may be held on with clips or double-sided tape. Gently pry the faceplate off of the camera body being careful not to damage any of the delicate components underneath.


How to Take off Ring Doorbell Without Tool

It is possible to take off the Ring Doorbell without a tool, but it is not recommended. The reason for this is because doing so can damage the doorbell or cause it to malfunction. If you must take off the doorbell, be sure to use a small flathead screwdriver or a putty knife.

Gently insert either one under the bottom lip of the faceplate and pry upward. Be careful not to damage the wires that are attached to the back of the faceplate.


If you need to take off the Ring Doorbell cover for any reason, it’s actually quite simple. There are just two small screws on the back that need to be removed. Once those are taken out, the cover should come right off.

If it’s stuck, you can use a flathead screwdriver to help pry it loose. Be careful not to damage the doorbell in the process.

Leave a Comment