You will need a small Phillips head screwdriver to take the faceplate off your Ring Doorbell. Start by unscrewing the two screws that are holding the faceplate in place. Once the screws are removed, gently pull the faceplate away from the doorbell.
No wires connect the faceplate to the doorbell, so it should come off easily. If you have trouble removing the faceplate, consult your Ring Doorbell manual for instructions.
- Open the faceplate by unscrewing the two screws at the top of the plate
- Carefully pull the faceplate away from the doorbell, being careful not to damage the wires
- Unscrew the wire connector from the back of the doorbell and remove the wires
- Screw the wire connector back onto the doorbell and reattach the wires
- Screw the faceplate back onto the doorbell and secure it in place with
How Do You Take the Faceplate off a Ring Doorbell Without a Tool?
There are a few ways to take the faceplate off a ring doorbell without a tool. The first is to use your fingers. If you can get a good grip on the edge of the faceplate, you should be able to pull it off with your fingers.
The second way is to use a flathead screwdriver. If you can find a small opening at the edge of the faceplate, you can insert the screwdriver and use it to pry the faceplate off. The third way is to use a putty knife.
Again, if you can find a small opening at the edge of the faceplate, you can insert the putty knife and use it to pry the faceplate off. Whichever method you choose, be careful not to damage the ring doorbell or its components as you remove the faceplate.
How Do I Remove My Doorbell Cover?
Assuming you’re talking about a traditional doorbell cover and not a device cover, first, locate the two screws holding it to remove your doorbell cover. These will be on either side of the body.
Once you have found them, use a screwdriver to loosen and remove them. With the screws removed, the cover should come right off. If it’s stubborn, gently pry it off with your screwdriver.
That’s all there is to it! Removing your doorbell cover is a quick and easy process that anyone can do.
How to Take Faceplate off Ring Doorbell Pro
If you need to take your Ring Doorbell Pro off its faceplate to access the battery or make other adjustments, here’s how to do it. First, remove the cover by unscrewing the two screws at the top. Then, gently pull on the bottom of the faceplate until it pops off.
Be careful not to damage the wires connecting the faceplate to the doorbell. Once you have removed the faceplate, you can access the battery and other components. To reattach the faceplate, snap it back into place and screw in the two screws at the top.
Conclusion
Assuming you would like a summary of the blog post titled “How to Take Faceplate off Ring Doorbell,”: The first step is to remove the battery cover by pressing the tab and sliding it off. Press and hold the orange button for 15 seconds with the body off.
This will put your Ring Doorbell into “Setup Mode.” Next, use a small screwdriver or pen to press and hold the setup button for 20 seconds. After that, release both buttons and wait one minute.
The faceplate can now be removed by gently pulling on it.
