If you’re like most people, you probably don’t think about your Ring Doorbell very often. But when the time comes to change the batteries or clean the lens, it can be a little tricky to figure out how to remove the cover. Here’s a quick guide on how to do it.

Start by pressing down on the tab at the top of the cover. Then, slide the cover off of the doorbell. Be careful not to lose any of the small screws that hold the cover in place.

Once the cover is off, you’ll have access to the battery compartment and other parts of the doorbell that may need cleaning or maintenance.

• Locate the two screws on the back of the Ring Doorbell
• Remove the screws with a Phillips head screwdriver
• Gently pull the cover off of the Ring Doorbell body
• There are no other fasteners holding the cover in place
• Set the cover aside and proceed to troubleshoot or replace whatever component you need inside the doorbell body

Credit: www.wikihow.com

How Do I Get My Ring Doorbell Cover off Without Tools?

There are a few ways to remove your Ring Doorbell cover without using any tools. The first way is to simply pry the cover off with your fingers. You may need to use a little bit of force, but the cover should come off relatively easily.

Another way to remove the cover is to use a flat head screwdriver. Insert the screwdriver into the small hole on the bottom of the doorbell and twist until the cover pops off. If you’re still having trouble removing the cover, you can try heating up the bottom of the doorbell with a hair dryer or heat gun.

This will soften the adhesive holding the cover in place, making it easier to remove.

Do I Take Plastic Cover off of Ring Doorbell?

Most people don’t realize that their Ring doorbell comes with a plastic cover. This is to protect the doorbell from the elements and to keep it clean. However, if you live in an area with high humidity or are worried about dirt and grime build-up, you may want to take the cover off.

Here’s how: 1. Use a Phillips head screwdriver to remove the four screws on the back of the ring doorbell. 2. Gently pull the back plate away from the rest of the unit.

Be careful not to lose any of the small parts or springs inside. 3. Take off the clear plastic cover by gently pulling it away from all sides until it pops off completely. You may need to use a flathead screwdriver to help pry it off in some areas.

4. You can now install your Ring doorbell without the plastic cover!

HOW TO REMOVE THE COVER ON A RING DOORBELL 2

How to Remove Ring Doorbell 2 Cover

If you’re like most people, your Ring Doorbell 2 is probably mounted outside your front door. And that means it’s exposed to the elements, which can take a toll on its appearance over time. Luckily, it’s easy to remove the cover and give your doorbell a quick cleaning.

Here’s how: 1. Start by unplugging the power cord from the back of the Ring Doorbell 2. 2. Next, use a small screwdriver or other tool to pry off the faceplate.

Be careful not to damage the faceplate as you remove it. 3. With the faceplate removed, you should now see four screws holding on the back plate. Remove these screws with a Phillips head screwdriver.

4. Finally, pull off the back plate and set it aside. You should now have full access to clean both sides of theRing Doorbell 2 unit itself!

Conclusion

If you need to remove the cover on your Ring Doorbell, there are a few things you need to do. First, you’ll need to unscrew the four screws that hold the faceplate in place. Once those are removed, you can carefully pry off the faceplate with a flathead screwdriver.

Be careful not to damage the wires behind the faceplate. Next, you’ll need to remove the two screws that hold the ring doorbell in place. Finally, you can pull off the cover and access the wires.